Please use another browser such as Chrome, Edge, Firefox, or Safari for the best experience

Skip to content Celestron EclipSmart 10 Pack

Astronomik OIII 6 nm CCD Filter - 31 mm Round

Free shipping
SKU: ASF-OIIICCD6-31
$239.95

Add Apertura Air Blower for Lens Cleaning to your order

$9.99
 

Astronomik OIII 6 nm CCD Filter - 31 mm Round

  • Presented in a round, 31 mm cell, this Astronomik OIII 6 nm CCD Filter is made especially for astrophotography
  • Transmission in the OIII line is close to 100%
  • FWHM bandwidth of nearly 6 nm
  • Ideally equipped for photographing planetary nebulae as well as the remaining vestiges of supernovae
  • Multi-layer coatings prevent this filter from being inflicted with scratches or the impacts of aging and humidity
  • Diffraction limited, this filter will not lessen the optical performance of your telescope
  • German-made for high optical quality!

More About the Astronomik 31 mm OIII 6 nm CCD Filter

For OIII emission line nebulae imaging from an ideally dark location or under heavily light polluted conditions, the Astronomik OIII CCD Filter offers complete impediment against mercury and sodium-vapor, the main causes of light pollution, as well as natural skyglow, and moonlight. The contrast between objects in the 501 nm doubly ionized oxygen line and the background is greatly enhanced. In addition, with this OIII 6 nm CCD Filter allows greenish and blueish targets to be photographed, considerably expanding your imaging potential.

A typical 96% transmission combined with a 6 nm narrow bandwidth provides a remarkable contrast gain since unwanted light from other wavelengths is fully blocked from UV up to IR. When compared to the 12 nm filter, the 6 nm OIII enables a higher contrast improvement due to its smaller FWHM (full width at half maximum). The result is an exceptionally dark background.

Astronomik OIII Filters are the perfect choice for viewing under extremely light polluted conditions as well as for imaging faint targets in parts of the Milky with densely crowded stars. 6 nm FWHM is matched to provide superior performance with CCD and CMOS sensors with exceptionally low dark current! Furthermore, due to a new MFR coating technique applied to this filter, it can be used on all instruments up to f/4 without sacrificing efficiency.

This filter is parfocal with all other Astronomik filters, a quality shared by all filters made by Astronomik. Even though it's only 1 mm thick, the Astronomik 31 mm OIII 6 nm Filter is remarkably resistant to damage caused by scratching, aging, and high humidity. This filter is also diffraction limited to prevent any reduction in your telescope's optical performance. As with all Astronomik filters, the 31 mm OIII 6 nm filter is delivered with a long-lasting plastic storage case of supreme quality.